Insertion electromagnetic flowmeters are designed
for use with conductive liquids in 1 to 48"” pipe. A choice of
materials (stainless steel, brass, and PVC) allows the meter
to adapt to a range of temperature, pressure, and corrosive
environments.
The EX series Insertion Magnetic Flow meter highly suitable for difficult applications with
changing viscosities and pulsating flows, such as air-driven
diaphragm pumps. With no moving parts, these meters can
be used in “dirty water” applications where debris would foul a
mechanical meter. Like all magmeters, when used in chemical
injection applications, these meters should be installed upstream
of the chemical line (or far enough downstream to allow complete
mixing of fluids before the meter).
Designed for modularity and versatility, the EX Series has
a current-sinking pulse output that can be combined with the
appropriate transmitter or indicator for the application.
For basic
rate/total and pulse output, the FT430 is best. For analog output
and display of rate and total, the FT440 can be used. Blind
analog output is provided by the AO55. The PD10 can be used to
divide the pulse for pacing chemical metering pumps. Electronic
modules can be wall- or meter- mounted. If the EX meter is
used with a programmable controller, the output signal can be
fed direct, with no other conditioning required.
EX-Series fi xed depth insertion meters require special fittings.
Factory installation in the fi tting ensures correct depth placement
in the pipe.
The EX-Series meter can be ordered in a full
power model when a source of electricity is available, or in a low
power model that can run on an external battery with solar panel.
Reverse fl ow output and immersibility are optional
There are three types of Insertion Magnetic Flow meter
EX800-Series insertion electromagnetic flowmeters are designed for use with conductive liquids in 1 to 12” pipe. A choice of materials (stainless steel, brass, and PVC) allows the meter to adapt to a range of temperature, pressure, and corrosive environments. The EX800 is highly suitable for difficult applications with changing viscosities and pulsating fl ows, such as air-driven diaphragm pumps. With no moving parts, these meters can be used in “dirty water” applications where debris would foul a mechanical meter. Like all magmeters, when used in chemical injection applications, these meters should be installed upstream of the chemical line (or far enough do | |
The EX100 Series are adjustable depth insertion magmeters that fi t 3” to 48” pipe (up to 72” optional). The complete lack of moving parts of the EX100-Series is the source of its reliability. Brass and stainless steel models withstand a variety of temperature, pressure, and chemical conditions. The EX-Series has no rotor to stop turning in dirty water and there are no bearings to wear out. Like all magmeters, when used in chemical injection applications, these meters should be installed upstream of the chemical line (or far enough downstream to allow complete mixing of fl uids before the meter). Adapters mate with standard 1-1/2” (11x/21x) or 2” (15x/25x) FNPT threaded fi ttings such as saddles and weldolets which may be purchased either locally or from Seametrics. | |
The EX200-Series are adjustable depth insertion magmeters that fi t 3” to 48” pipe (up to 72” optional). The complete lack of moving parts of the EX200-Series is the source of its reliability. Brass and stainless steel models withstand a variety of temperature, pressure, and chemical conditions. The EX-Series has no rotor to stop turning in dirty water and there are no bearings to wear out. Like all magmeters, when used in chemical injection applications, these meters should be installed upstream of the chemical line (or far enough downstream to allow complete mixing of fl uids before the meter). Adapters mate with standard 1-1/2” (11x/21x) or 2” (15x/25x) FNPT threaded fi ttings such as saddles and weldolets which may be purchased either locally or from Seametrics. rudy |