Bamo Magnetic Level Controllers MNR 6

Reed contacts are adjusted at factory according requested trigger points; They are actuated by the magnetic float. Wet parts are in PVC, PPH, PVDF or stainless steel.

Quick commissioning:

Trigger point distances are determined prior to manufacture in relation to the sealing surface, in order to ensure the correct position of the contacts. The float can be removed from the bottom of the MNR6 controller (end stop ring removed). it is useful to order the option 2'' coupler or a flange NB 50 to allow the float introduction from the tank top when possible.

Recommendations:

The use of a relay ES2001 is recommended to protect the Reed contact by a low intensity current in the loop and to procure a great longevity to the device.

Features

• Versions: PVC, PPH, PVDF or AISI 316
• 1 or 2 changeover contacts
• Reduced dimensions
• No effects of foam and vapours
• Measuring height: Up to 1500 mm

Application

Pumps and solenoid valves automation, low and high alarm signals, overfill detection, etc. The MNR 6 series is recommended for non-viscous, non-sticky liquids and without magnetic particles or suspended solids.

Specification

Trigger point distances	From sealing surface: Min. 250 mm, Max. 1500 mm
Temperature limits	PVC-U: 5 ... +50 °C; PPH: -5 ... +80 °C
	PVDF: -10 ... +110 °C; AISI 316 L: -20 ... +110
Pressure limits	°C Max. 3 bar at 20 °C for plastic versions
	Max. 20 bar at 20 °C for stainless steel version
Materials
Stem and fitting	PVC, PP, PVDF or AISI 316 L
Float	PP, PVDF or AISI 316 L
Head housing	PBT for plastic versions; IP 65 (or DIN Plug IP 65)
	Aluminum alloy for AISI 316L version; IP 54 (or DIN plug IP 65)
Output signals:
Number of contacts	1 or 2 changeover contacts
Switching power	60VA/220V/1A
Terminals	Terminal board head housing or DIN Plug or cable output (3 m)
Gap between two contacts	Min. 100 mm
Accuracy	± 2 mm
Hysteresis	8 mm

Download Data Sheet: Magnetic Level Controllers MNR 6

Ref: bamo.eu