DuroTec® Gear Pumps DT 5 for abrasive and poor lubricating fluids. In the year 1990, KRACHT initiated the development of Gear Pumps for abrasive and poor lubricating fluids. Since then, this development has been subsequently improved. The gear (gear wheel and shafts) is surrounded by SIC sleeve bearing. The gear is high-rigid protected against wear, taken the requirements regarding material, heat treatment, surface geometry into consideration when using this coating technology. Highest demands have been fulfilled by our own manufacturing quality and the involved coating specialists.
The limit of applications of Gear Pumps has been reached when the transfer medium does not have the required lubricity for a proper function of the pump and a high operating pressure is needed at the same time. Such problematic fluids are for example silicates (sodium silicate), isocyanates and polyols with hard fillers as can be found in the PUR-technology. Under air or humidity influence, crystallisation of these fluids occurs and agrivates the lack of lubricity.
Application:
The main field of application for the new DuroTec® Gear Pumps DT 5 are mainly multicomponent-systems in the PUR-technology. Everywhere where standards Gear Pumps do not reach a satisfying lifetime, e.g. where polyols with
hard fillers have to be handled, this Gear Pump offers a reliable alternative
Another Article: |
Specification:
Materials
Housing | EN-GJL-300 (GG 30) |
Flange cover | EN-GJL-300 (GG 30) |
Gearing | Steel, hard material coated |
Sliding plates | Steel, nitrated |
Bearing | Sleeve bearing SIC |
Shaft sealing | Mechanical seal with Quench chamber incl. Quench tank |
Characteristics
Geometrical displacement | Vg | 150, 200, 250 cm3/r | |
Mounting position | horizontal | ||
Fixing type | Flange (SAE-C-2-hole flange) | ||
Inlet port | SAE 21⁄2" flange | ||
Outlet port | SAE 2" flange | ||
Max. operating pressure | 100 bar | ||
Max. inlet pressure | 20 bar | ||
Viscosity | mm2/s | 13 up to 50 000 | |
(higher viscosities on request) | |||
Fluid temperature | max. 150 °C | ||
Ambient temperature | ϑu min | = | – 20°C |
ϑu max | = | 60 °C | |
Shaft end | Cylindrical shaft Ø 32 mm | ||
Download Data Sheet: Duo Tec - Gear Pump DT 5 Series
Ref: Krachtcorp.com
Komentar
Posting Komentar
Informasi Pilihan Identitas:
Google/Blogger : Khusus yang punya Account Blogger.
Lainnya : Jika tidak punya account blogger namun punya alamat Blog atau Website.
Anonim :