Eurosens DDS converts the angle of rotation of the sensor’s lever to the output signal. As the transducer is used a magnetoresistive sensor. At the output of the sensor is formed stabilized analog voltage signal, which corresponds to the angular position of the pivot arm, changing depending on the load on the axle vehicle.

Eurosens DDS A output voltage :

Rotation angle, degrees	The output voltage, V
– 40	1,54
– 30	1,78
– 20	2,02
– 10	2,26
0	2,50
10	2,74
20	2,98
30	3,22
40	3,46

Eurosens DDS RS uses LLS/MODBUS protocol

Eurosens DDS CAN uses CAN bus J1939 protocol with configurable PGN.

After installation and wiring Eurosens DDS, you should perform a calibration in which you are mapping the output voltage to the load on the suspension of the vehicle.

Leuze Optical Distance Sensors

Seko Sensor Probe for Control

Nivelco Temperature Measurement

Kofloc RK 1200 Oxygen 1/2 inch Flow Meter

EGE Elektronik Inductive Proximity Switches