Mechatronics Eurosens DPS A (RS, CAN) converter

    

Eurosens DDS converts the air pressure in the output voltage or digital messages via serial RS485 or automotive CAN bus J1939 protocol. As the pressure transducer thin-film bridge is used.

Eurosens DPS A output :

Pressure, Mpa	The output voltage, V
0	0,25
0,1	0,70
0,2	1,20
0,3	1,55
0,4	2,00
0,5	2,50
0,6	2,95
0,7	3,30
0,8	3,80

Eurosens DPS RS uses LLS/MODBUS protocol

Eurosens DPS CAN uses CAN bus J1939 protocol with configurable PGN.

After installation and wiring Eurosens DPS should perform a calibration in which you are mapping the output signal to the load on the suspension of the vehicle.

Read more article : 

Delphin Technology Expert Logger

Deep Sea Electronic DSEE050 Engine Display and Controller

B+B SmartWorx SmartStart™ Smart Hardware

Fluidwell D490 Indicator untuk Berbagai Aplikasi Peralatan Instrument

ACR Artex C-Light Manual Activated Personal Distress Light