Mechatronics Fuel Level Monitoring Eurosens Dominator AF Type

EUROSENS Dominator AF replaces the sensors with analog output of 5V, the analog output of 10V, and with frequency output in the range of 500 – 1500 Hz.

• • High-precision measurement
  • Built-in temperature compensation
  • Output signal type can be adjusted
  • Strong electronic circuit protection
  • Efficient packaging, installation, and sealing
  • Modular build
  • Sealed automobile connector on the sensor body

Dominator fuel level sensors are designed to minimize the operating costs of a fuel consumption monitoring system for the entire period of its operation.

• Powerful electronic module protection. External power voltage protection up to 170 volts.
  
  
• The modular design makes it easy to provide technical support for installed sensors. We can easily localize the problem either in the sensor “head” or in sensor electrodes because electrodes can be disconnected from the sensor “head”.
  
  
• The modular design allows not only cutting the sensor for a specific vessel but also extending the electrode. It's useful when you reinstall the system to another object. Sensors of the traditional non-modular design can’t be extended and once shortened electrodes can’t be replaced.
  
  
•  If the fault is in the “head” of the sensor – replacement can be done even by the end-user – the owner of the equipment. Thanks to the bayonet, fast-lock replacement is very easy and takes about 10 minutes. It is much cheaper than the travel costs of the installation staff.
  
  
• Easy sealing of the sensor from disconnection cable and sensor removal.
  
  
• The electrodes can be easily disassembled and cleaned. Sensors of conventional design can be contaminated in the gap between electrodes which require complex maintenance. Dominator electrodes can be cleaned by the customer without warranty violations.
  
  
• After sensor “head” replacement you don’t need to make tank calibration again (unlike traditional design sensors).
  
  
• Warranty term – 5 years.

Specification :

Power voltage, V	9 – 32
Reverse polarity protection	Yes
Max error	±1%
Temperature range,°C	-40 – +85
The output voltage, V	0,5 – 9,5
Output frequency, Hz	500 – 1500
Seal rating	IP 67
Galvanic isolation	up to 500V

Reference: mechatronics.by